随着无锡企业对环氧地坪产品了解，越来越多的场合开始使用无锡环氧地坪，要做出优质的环氧地坪漆工程，除了要选择正规无锡环氧地坪施工厂家的地坪漆材料，严格按照地坪漆施工工艺进行施工之外，在地坪漆施工前、施工中、施工后还要注意以下细节：

With people's understanding of epoxy floor paint products, more and more occasions began to use epoxy floor paint, to make high-quality floor paint project, in addition to the choice of normal floor paint manufacturer's floor paint materials, in strict accordance with the construction process of floor paint construction, before, during and after the construction of floor paint, the following details should be paid attention to: 

一、施工前的准备工作：

Preparations before construction:

1、检查基础地面情况：是否平整，将过高或过低位置做好标识，对其进行打磨或修补。

1. Check the ground condition of the foundation: Whether it is flat or not, mark the position too high or too low, and grind or repair it.

2、要清楚知道地面的养护时间，施工环境的情况，温度、湿度、是否有防水层等。因为环氧地坪漆的施工是受环境的影响的，温度不能过高或过低，湿度也要在合适的范围内。夏天的养护时间是7天，温度低或比较潮湿的地方则10天。

2. Know clearly the maintenance time of the ground, the construction environment, temperature, humidity, whether there is a waterproof layer, etc. Because the construction of epoxy floor paint is affected by the environment, the temperature should not be too high or too low, and the humidity should also be within the appropriate range. Maintenance time is 7 days in summer and 10 days in low or humid areas.

3、检查混凝土地面的强度。这是为了防止施工后环氧地坪漆出现起砂、空鼓等不良现象。强度较低的混凝土地面，在施工前要特别注意吸尘，清理干净后，涂刷上环氧封闭底漆，将混凝土地面的毛细孔封闭起来，阻止水汽，杂物等渗入地面，增强混凝土地面的强度。

3. Check the strength of concrete floor. This is in order to prevent the occurrence of sand, empty drum and other undesirable phenomena in epoxy floor paint after construction. The concrete floor with lower strength should be cleaned up before construction. After cleaning, epoxy sealing primer should be applied to seal the capillary holes of the concrete floor to prevent water vapor and sundries from penetrating into the ground and enhance the strength of the concrete floor.

4、检查施工场所环境是否洁净。如果环氧地坪漆混入灰尘等杂物的话，会使环氧地坪出现颗粒状或不平整的情况。

4. Check whether the environment of the construction site is clean. If the epoxy floor paint is mixed with dust and other impurities, it will make the epoxy floor appear granular or uneven.

二、施工过程中需要注意的地方：

2. The points needing attention in the construction process:

1、材料配比的量要精准，地坪漆材料要搅拌均匀。

1. Material proportioning should be precise and flooring paint materials should be stirred evenly.

2、施工时涂布的涂层厚度在均匀，固化实干后才可以进入下道工序。

2. The coating thickness is uniform during construction and can enter the next process only after solidification and drying.

3、每施工一道涂层后检查下施工后的涂布表面是否有质量问题，及时处理。

3. Check the quality of the coated surface after each coat construction, and deal with it in time.

4、注意保持施工环境的卫生，避免脏物掉入未固化的涂层中。

4. Attention should be paid to the hygiene of the construction environment to avoid the dirt falling into the uncured coating.

三、施工后需要注意的地方：

3. Points needing attention after construction:

1、地坪漆涂层全部施工完毕后，清理现场把所的施工工具和材料全部带离现场。

1. After finishing the construction of the floor paint coating, clean up the site and take all the construction tools and materials away from the site.

2、24小时固化后待表面涂膜完成固化可上人行走，三天后检收，一周后可投入使用。

2. After curing for 24 hours, it can walk on the surface until the film is cured. After three days, it can be checked and put into use after one week.

3、投入使用后的环氧地坪工程要注意维护保养，禁止破坏，定期检查环氧涂层的表面情况，有损坏的及时报修。

3. After putting into use, the epoxy floor project should pay attention to maintenance, prohibit damage, regularly check the surface condition of the epoxy coating, and timely report the damage.